Strong & Safe Anilox Roll & Ink Cleaner

100% Biodegradable formula - Safe for your employees and the environment. The most powerful and fastest-acting anilox roll cleaner available anywhere, dissolves ink on contact. On-press cleaning reduces risk of damage from ultrasonic or soda-blast cleaning. Removes all dried UV, solvent-based and water-based inks. Money Back Guaranteed! Product Information Looking for the best all-around cleaner this industry has ever known?  Need something to come in and do the job that others can't?  Try our Strong & Safe Anilox Roll Cleaner.  This super-concentrated, safe solution is packed with a blend of active, modern, environmentally-friendly cleaners.  This chemical rich concentrated formula is loaded with ink-attacking, cleaner safe solvents and powerful soaps. Mix at 1:1 with water for old, stubborn ink or as a periodic cleaner.  For daily cleaning, mix 4:1 or higher dilution with water as conditions allow.  Performs excellent in any ultrasonic cleaning tank or soak system.  Effective and safe on both ceramic and chrome anilox rolls.  Use to remove ink from any anilox and as a general purpose cleaner.  Try our best performing product today!

Product Uses and Mixing Ratios Use for in-press or off-press daily or periodic cleaning of any chrome or ceramic anilox roll.  Start at full strength or 1:1 mixing ration (1 gallon water to 1 gallon cleaner) for old, stubborn ink up to 4:1 (4 gallons water to 1 gallon cleaner) or a higher dilution as conditions allow.  Spray or pour on any type of anilox roll, scrub with appropriate brush, then rinse off with water. For use in ultrasonic or soak tank anilox roll cleaning system, start at 1:1 to 4:1 or a higher dilution as conditions allow.  For use as removing all inks as a general purpose cleaner, or for use on floors, counter tops, stainless steel and other hard surfaces, start at full strength to 4:1 ratio and higher dilution as conditions allow. For the best performing photopolymer plate cleaner available anywhere, try our Safety Clean Photopolymer Plate Cleaner. Cleans wet and dried water-based inks, UV cured inks, solvent-based inks and adhesives, coatings and varnishes from any chrome or ceramic anilox roll and virtually any surface as a general purpose ink remover/cleaner.   Chemical Safety Readily biodegradable, environmentally-friendly, pH stable, non-corrosive, non-toxic, non-combustible, non-fuming, not Sara 313 listed, nonflammable, no flash point, no fire hazard, 0-flammability rating, non-ozone depleting, and low-aquatic toxicity.  Contains no chlorinated solvents, no petroleum distillates, no EPA Hazardous Air Pollutants (HAP), no carcinogens, and no marine pollutants.  Product contains no ingredient that causes carcinogenic effects, mutagenic effects, teratogenic effects, or developmental toxicity.  Passes plate compatibility testing. NFPA rating Health (NFPA):  1, Flammability:  0, Reactivity:  0. HMIS rating Health (HMIS):  1, Flammability:  0, Reactivity:  0.   Chemical Attributes Water-based, water soluble formula, Appearance:  clear liquid, Odor:  minimal, pH concentrate = 10.75 diluted 1:1=10.66, pH diluted 4:1=10.5, Total % VOC: 0.3%